Example: Resonance VROA: H2O2

Download VROA_RESO.run

Example shows a calculation of resonance vibrational Raman optical activity (resonance VROA).

In the ADF input one then needs to include the subkey FREQUENCIES of the key GEOMETRY (numerical frequencies) and include the subkeys VROA and LIFETIME of the key AORESPONSE. A laser frequency need to be added. The other keys in AORESPONSE are recommended by the author of the implementation of VROA in ADF. For accuracy reasons ‘NumericalQuality Good’ and EXACTDENSITY are used. Note that the subkey FitAOderiv is only used in case of pair fitting (STOFIT), in which case it will improve the fit quality. The default fit method is ZlmFit, which will not use this key. In case of ZlmFit one should set the numericalquality or ZlmFit quality to a high level, for example Good or VeryGood.

$ADFBIN/adf << eor
title VROA TEST H2O2

basis
 type TZP
 core None
end

ATOMS
    1.O        -0.750254   -0.034490    0.015133
    2.O         0.750254    0.034490    0.015133
    3.H        -0.943532    0.744006    0.580040
    4.H         0.943532   -0.744006    0.580040
END

xc
 gga BLYP
end

GEOMETRY
frequencies
END
exactdensity

NumericalQuality Good

aoresponse
 NEWPOLCODE
 VROA
 scf  converge 1d-6 iterations 100
 frequency 1 5.15462 eV
 lifetime 0.0037
 ALDA
 FitAOderiv
 EL_DIPOLE_EL_DIPOLE VELOCITY
 EL_DIPOLE_EL_QUADRUPOLE VELOCITY
 EL_DIPOLE_MAG_DIPOLE VELOCITY
end

END INPUT
eor

Note that used basis set is too small to get accurate results. Better is the use larger basis sets, like one of the even tempered basis sets (for example Type ET/ET-QZ3P-1DIFFUSE), or use augmented basis sets (for example Type AUG/ATZ2P).